Trimming car bottom punching machine
This equipment is used for cutting, trimming and punching of carbon steel, stainless steel, aluminum and other metal round workpieces. Three stations are completed on one equipment.
Main equipment configuration: 1) the main body of the equipment is welded with square tube steel plate; 2) the main motor drives the center drive part to rotate through the transmission and sprocket; 3) the upper pressure cylinder is supported by the gantry; 4) the cutting station, trimming station and punching station are installed on the table top of the equipment body; 5) the hydraulic cylinder is used as the power of trimming station, upper pressing mechanism and punching station; 6) servo motor is used for edge sweeping and working (7) the displacement during position conversion, 7) the loading rotating arm platform swings the workpiece in and out, 8) the cylinder jack up and place the workpiece, 9) the hydraulic station drives the hydraulic system, and 10) the electrical control system PLC.
Pre: Automatic trimming machine Next: One time and two times trimming machine |